LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> HHR LS, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Diagnostic Information and Procedures >> DTC P0520 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the EOP switch.
  2. Ignition OFF, test for less than 1 ohm of resistance between the ground circuit and ground.
    • If greater than 1 ohm, test the ground circuit for an open/high resistance.
  3. Ignition ON, install a 3-amp fused jumper wire between the signal circuit and ground. Verify the scan tool Engine Oil Pressure Switch parameter is Low.
    • If not Low, test the signal circuit of the EOP switch for an open/high resistance. If the circuit tests normal replace the ECM.
    • If low, replace the EOP switch.
scientia non olet · About LEMON Manuals