LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> HHR L4-2.2L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Drive Belt Tensioner >> Service and Repair

Drive Belt Tensioner: Service and Repair



Drive Belt Tensioner Replacement
Removal Procedure





1. Remove the drive belt.
2. Remove the drive belt tensioner bolt.
3. Remove the drive belt tensioner.

Installation Procedure





1. Position the drive belt tensioner.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the drive belt tensioner bolt.
Tighten the bolt to 45 Nm (33 ft. lbs.).
3. Install the drive belt.
scientia non olet · About LEMON Manuals