Wheel Bearing/Hub Replacement - Front

Fig 1: Replacing Front Wheel Bearing/Hub

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Refer to Lifting and Jacking the Vehicle . Refer to Tire and Wheel Removal and Installation (5 Lug Wheel) or Tire and Wheel Removal and Installation (4 Lug wheel) . Refer to Brake Rotor Replacement - Front .
1	Nut, Axle Shaft Tighten: 110 N.m (81 lb ft)
2	Connector, Wheel Speed Sensor Tip: If equipped.
3	Bolt, Wheel Bearing Bearing/Hub Assembly (Qty: 3) Tighten: 115 N.m (85 lb ft)
4	Bearing, Wheel Bearing/Hub Assembly
5	Spacer, Wheel Bearing/Hub Assembly