LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transmission Clutch System) >> Repair Instructions >> Hydraulic Clutch Hose/Pipe Replacement (MU3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Clutch Hose
GM1549845Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Ensure that the clutch line locks securely in place.
  1. Connect the clutch line (2) to the clutch master cylinder and the transaxle.
  2. Connect the clutch hose (1) to the clutch actuator cylinder and the brake master cylinder reservoir.
  3. Remove the shop towel and discard in a suitable container.
  4. Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement in Wiring Systems.
  5. Fill the brake/clutch reservoir with DOT 3 hydraulic fluid to the proper fluid level.
  6. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .
scientia non olet · About LEMON Manuals