LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Position Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Removing/Installing CPP Switch From/To Clutch Pedal
GM1547861Courtesy of GENERAL MOTORS CORP.
  1. A 3/32 inch or 2 mm drill bit can be used as a gage tool for the proper adjustment of the CPP switch. Insert and seat the 3/32 inch or 2 mm drill bit through the slot in the top of the clutch pedal assembly.
  2. Install the CPP switch (1) to the clutch pedal assembly.
  3. While holding the pedal in the fully released position, press the switch (1) toward the pedal until the barrel of the switch touches the drill bit on the pedal assembly.
  4. Rotate the switch (1) clockwise to secure.
  5. Remove the drill bit.
  6. Connect the electrical connector (2) to the CPP switch (1).
scientia non olet · About LEMON Manuals