LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Master Cylinder Replacement (MU3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Clutch Master Cylinder
GM1549851Courtesy of GENERAL MOTORS CORP.
IMPORTANT: While installing, ensure that the clutch master cylinder pushrod is aligned with he clutch pedal.
  1. Install the clutch master cylinder while rotating 1/4 turn counterclockwise.
  2. Uncap the reservoir and hydraulic lines.
    3. Fig 2: Clutch Hose
    GM1549845Courtesy of GENERAL MOTORS CORP.
  3. Connect the clutch line (2) to the clutch master cylinder.
  4. Connect the clutch hose (1) to the clutch master cylinder.
  5. Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement in Wiring Systems.
  6. Connect the clutch master cylinder pushrod to the clutch pedal.
  7. Install the clutch pedal retainer.
  8. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .
scientia non olet · About LEMON Manuals