LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Drive Plate and Clutch Driven Plate (MU3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Clutch Cover And Clutch Disc
    GM100733Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch disc and the clutch cover.
  2. Hand start the clutch cover to flywheel bolts, leaving the clutch cover loose enough to reposition for alignment.
    3. Fig 2: View Of J 43482 Supporting The Clutch Cover
    GM892789Courtesy of GENERAL MOTORS CORP.
  3. Install the J 43482  in order to support the clutch cover to the flywheel assembly. See Special Tools .
    Fig 3: Installing Clutch Cover-To-Flywheel Bolts
    GM100744Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Tighten the clutch cover to flywheel bolts in the sequence shown.

    Tighten:  Tighten the bolts to 30 N.m (22 lb ft).

  5. Recheck each bolt torque using the tightening sequence.
  6. Remove the J 43482  . See Special Tools .
    IMPORTANT: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.
  7. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
  8. Install the transmission. Refer to Transmission Replacement in Manual Transmission - MU3.
  9. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding .
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals