LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Manual Transaxle - Mu3 - Service & Diagnosis) >> Repair Instructions >> Transmission Mount Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the underhood electrical center bracket from the vehicle and reposition the electrical center. Refer to Underhood Electrical Center or Junction Block Bracket Replacement in Wiring Systems.
    2. Fig 1: Supporting Engine/Transmission With Hydraulic Floor Jack
    GM851552Courtesy of GENERAL MOTORS CORP.
  2. Support the transmission with a floor jack. Use a piece of wood between the jack and the transmission.
    3. Fig 2: View Of Transmission Mount To Transmission Bolts
    GM1376169Courtesy of GENERAL MOTORS CORP.
  3. Remove the transmission mount-to-transmission bracket bolts.
    4. Fig 3: View Of Transmission Mount-To-Mid-rail Bolts
    GM851557Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission mount to mid-rail bolts.
    5. Fig 4: Supporting Engine/Transmission With Hydraulic Floor Jack
    GM851552Courtesy of GENERAL MOTORS CORP.
  5. Using a floor jack, slowly lower the transmission enough to remove the transmission mount from the vehicle.
scientia non olet · About LEMON Manuals