LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Manual Transaxle - Mu3 - Service & Diagnosis) >> Repair Instructions >> Shift Control Knob Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Use adhesive Loctite™ 270 with Activator 7471 or Activator 7649. DO NOT operate the lever until the adhesive has dried (approximately 30 minutes).
  1. Apply adhesive to the knob.
  2. Seat the shifter knob over the shifter lever. Ensure the spring and foam rings are correctly seated.
  3. Position and fit the emblem over the shifter knob.
  4. Vacuum and clean any debris.
scientia non olet · About LEMON Manuals