LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Transmission Fluid Checking Procedure

Transmission Fluid Checking Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (5 Lug Wheel) or Tire and Wheel Removal and Installation (4 Lug wheel) in Tires and Wheels.
    2. IMPORTANT: Inspect the fluid level only when the engine is off. Ensure the vehicle is level. The transaxle must be cold.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 1: Locating Fluid Level Check Plugs
    GM857189Courtesy of GENERAL MOTORS CORP.
  3. Remove the level check plug.
  4. Verify that the fluid is up to the opening.
  5. If no fluid is visible, add Dexron III P/N 21019223 Transmission Fluid, or equivalent until the level check opening begins to leak fluid.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the fluid level check plug.

    Tighten:  Tighten the fluid level check plug to 38 N.m (28 lb ft).

  7. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (5 Lug Wheel) or Tire and Wheel Removal and Installation (4 Lug wheel) in Tires and Wheels.
scientia non olet · About LEMON Manuals