LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Axle Shaft Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation (5 Lug Wheel) or Tire and Wheel Removal and Installation (4 Lug wheel) in Tires and Wheels.
  3. Remove the wheel driveshaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
    4. Fig 1: Removing Front Wheel Drive Shaft Oil Seal
    GM863208Courtesy of GENERAL MOTORS CORP.
  4. Use theSA9133T  in order to remove the seal.
  5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.
scientia non olet · About LEMON Manuals