LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Axle Shaft Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Wheel Drive Shaft Into Transaxle Through J 44394
    GM857191Courtesy of GENERAL MOTORS CORP.
  1. Use the J 44385  and the J 7079-2  in order to install a new seal. Ensure that the seal is seated flush to the outer bore area.
  2. Lubricate the seal with Dexron® III transmission fluid Saturn P/N 21019223.
  3. Install the wheel driveshaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
  4. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (5 Lug Wheel) or Tire and Wheel Removal and Installation (4 Lug wheel) in Tires and Wheels.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals