LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Powertrain Mount Balance Procedure - Lower Mount

Powertrain Mount Balance Procedure - Lower Mount

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.
    Fig 1: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Loosen the front transaxle mount through bolt.
    3. Fig 2: Identifying Rear Transaxle Mount Through Bolt
    GM1647340Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear transaxle mount through bolt.
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    5. Fig 3: Identifying Rear Transaxle Mount Through Bolt
    GM1647340Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Tighten the rear transaxle mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

    6. Fig 4: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
  6. Tighten the front transaxle mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals