LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount
    GM1647351Courtesy of GENERAL MOTORS CORP.
  1. Place the engine mount onto the side rail studs.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine mount to side rail nuts.

    Tighten:  Tighten the nuts in the sequence shown to 100 N.m (74 lb ft).

    3. Fig 2: View of engine mount to bracket bolts
    GM1656093Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The engine mount to bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Install the engine mount to bracket bolts.
  4. Tighten the engine mount to bracket bolts.

    Tighten:  Tighten the bolts in the sequence shown to 50 N.m (37 lb ft).

  5. Remove the hydraulic floor jack from under the oil pan.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals