LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of engine mount bracket to engine bolts
    GM1656094Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount bracket to the engine.
  2. Install the engine mount bracket bolts in the following locations:
    • The long bolts in the forward and lower front holes
    • The short bolt in the upper rear hole
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the engine mount bracket bolts.

    Tighten:  Tighten the bolts in the sequence shown to 100 N.m (74 lb ft).

  4. Install the engine mount. Refer to Engine Mount Replacement .
scientia non olet · About LEMON Manuals