LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Front Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Front Cover Gasket
    GM1578294Courtesy of GENERAL MOTORS CORP.
  1. Position and install a NEW engine front cover gasket to the dowel pins.
    2. Fig 2: Identifying Engine Front Cover
    GM1578293Courtesy of GENERAL MOTORS CORP.
  2. Position and install the engine front cover.
    3. NOTE: Refer to Fastener Notice .
  3. Install the engine front cover to water pump bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    4. Fig 3: Identifying Engine Front Cover Bolts
    GM1578292Courtesy of GENERAL MOTORS CORP.
  4. Install the engine front cover bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    5. Fig 4: View Of Drive Belt Tensioner
    GM1571145Courtesy of GENERAL MOTORS CORP.
  5. Install the drive belt tensioner.
  6. Install the drive belt tensioner bolt.

    Tighten:  Tighten the bolt to 45 N.m (33 lb ft).

  7. Install the engine mount bracket. Refer to Engine Mount Bracket Replacement .
  8. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
scientia non olet · About LEMON Manuals