LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Flywheel (Manual Transaxle)
    GM1578311Courtesy of GENERAL MOTORS CORP.
  1. Install the manual transaxle flywheel.
    2. NOTE: Refer to Fastener Notice .
  2. Install the manual transaxle flywheel bolts.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059  .

  3. Install the automatic transaxle flywheel bolts.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059  .

  4. Remove the J 38122-A  .
  5. If equipped with a manual transaxle, install the clutch. Refer to Clutch Drive Plate and Clutch Driven Plate (M86) or Clutch Drive Plate and Clutch Driven Plate (MU3) .
  6. If equipped with a automatic transaxle, install the transaxle. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals