LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Crankshaft Rear Oil Seal
    GM1578312Courtesy of GENERAL MOTORS CORP.
  1. Remove the flywheel. Refer to Engine Flywheel Replacement .
    2. IMPORTANT: Do not damage the outside diameter of the crankshaft or chamber with any tool.
  2. Pry out the crankshaft rear oil seal using a flat-bladed tool.
scientia non olet · About LEMON Manuals