LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Crankshaft Rear Oil Seal
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Using the J 42067  , install a NEW crankshaft real oil seal.
  2. Install the flywheel. Refer to Engine Flywheel Replacement .
scientia non olet · About LEMON Manuals