LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Balancer
    GM412138Courtesy of GENERAL MOTORS CORP.
  1. Position the crankshaft balancer.
  2. Install a NEW crankshaft balancer bolt.
    3. Fig 2: View Of Harmonic Balancer Holder J38122-A
    GM467429Courtesy of GENERAL MOTORS CORP.
  3. Use the J 38122-A  to hold the crankshaft balancer in order to prevent the balancer from rotating while tightening the bolt.
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the crankshaft balancer bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft) plus an additional 125 degrees using the J 45059  .

  5. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals