LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Flywheel Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Flywheel
    GM412119Courtesy of GENERAL MOTORS CORP.
  1. Install the flywheel.
  2. Install the NEW bolts.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Holding the crankshaft balancer with J 38122-A  , tighten the bolts evenly.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the J 45059  .

scientia non olet · About LEMON Manuals