LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Disassemble >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Cylinder Head Air Bleed Tube
    GM1244844Courtesy of GENERAL MOTORS CORP.
  1. Remove the coolant air bleed hose fitting.
    2. Fig 2: Identifying Valve Spring Keepers
    GM1403900Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the valve train components are kept together and identified in order for proper re-installation in their original position.
  2. Using the J 8062  and the J 43963  , compress the valve spring.
  3. Remove the valve keys.
  4. Slowly release the J 8062  and the J 43963  from the valve spring assembly.
  5. Remove the retainer.
    6. Fig 3: Identifying Valve Springs
    GM1403902Courtesy of GENERAL MOTORS CORP.
  6. Remove the spring.
    7. Fig 4: Identifying Valve Seals
    GM1403906Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not damage the valve guide. Remove any burrs that have formed at the key groove by chamfering the valve stem with an oil stone or a file.
  7. Remove the valve seal. Use the J 36017  . Do not reuse.
    8. Fig 5: Identifying Engine Valves
    GM412477Courtesy of GENERAL MOTORS CORP.
  8. Remove the valve.
  9. Remove the remaining valves.
    10. Fig 6: View Of Cylinder Head Plugs
    GM412478Courtesy of GENERAL MOTORS CORP.
  10. Remove the cylinder head plugs.
scientia non olet · About LEMON Manuals