LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Throttle Body
    GM1623767Courtesy of GENERAL MOTORS CORP.
  1. Install the throttle body.
    2. NOTE: Refer to Fastener Notice .
  2. Install the throttle body bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Identifying TAC Electrical Connector
    GM1647528Courtesy of GENERAL MOTORS CORP.
  3. Connect the TAC electrical connector (1).
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals