LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor
    GM1656943Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the MAF/IAT sensor screws.

    Tighten:  Tighten the screws to 0.6 N.m (5 lb in).

    3. Fig 2: Connecting Engine Harness Electrical Connector To MAF/IAT Sensor
    GM1647998Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine harness electrical connector to the MAF/IAT sensor.
scientia non olet · About LEMON Manuals