LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the NEW MAP sensor seal with clean engine oil.
    2. Fig 1: Installing MAP Sensor Into Intake Manifold
    GM1581050Courtesy of GENERAL MOTORS CORP.
  2. Install the MAP sensor into the intake manifold.
  3. Connect the engine harness electrical connector to the MAP sensor.
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals