LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting Knock Sensor (KS) Electrical Connector
    GM1656089Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the knock sensor (KS) electrical connector (3).
  2. Remove the KS bolt.
    3. Fig 2: Identifying Knock Sensor
    GM1578476Courtesy of GENERAL MOTORS CORP.
  3. Remove the KS.
scientia non olet · About LEMON Manuals