LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Injector Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fuel Rail Assembly Component View
    GM854298Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel rail. Refer to Fuel Rail Assembly Replacement .
  2. Remove the fuel injector retainer clip (3).
  3. Remove the fuel injectors (5) from the fuel rail.
    4. IMPORTANT: Visually inspect the fuel injector in order to determine if the upper O-ring was also removed. If the upper O-ring is not removed, remove the O-ring from the fuel rail assembly.
  4. Remove and discard the fuel injector O-rings (4, 7).
scientia non olet · About LEMON Manuals