LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
  2. Disconnect the fuel feed line quick connect fitting (4) from the fuel rail. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    3. Fig 1: Identifying Fuel Line
    GM1647977Courtesy of GENERAL MOTORS CORP.
  3. Cap or plug the fuel line and the fuel rail to prevent contamination.
  4. Remove the fuel feed line retainers (1, 2) from the engine brackets.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the evaporative emission (EVAP) canister. Refer to Evaporative Emission (EVAP) Canister Replacement 
    7. Fig 2: Identifying Fuel Feed Line
    GM1651517Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the fuel feed line (1) from the fuel filter. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    8. Fig 3: View Of Rear Brake Pipe Bracket Retaining Nut
    GM890000Courtesy of GENERAL MOTORS CORP.
  8. Remove the rear brake pipe bracket nuts and release the brackets from the body studs.
    9. Fig 4: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  9. Release the pipe retainers (1) from the vehicle underbody.
  10. Remove the fuel feed pipe from the pipe retainers.
  11. Lower the rear of the pipe while moving the pipe rearward slightly, then lower the front of the pipe.
  12. Remove the fuel feed pipe from the vehicle.
scientia non olet · About LEMON Manuals