LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement 
    3. Fig 1: Identifying EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the evaporative emission (EVAP) canister purge tube from the purge valve. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Disconnect the EVAP purge tube from the intake manifold. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Remove the EVAP canister valve purge tube.
scientia non olet · About LEMON Manuals