LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  1. Remove the EVAP canister valve purge tube.
  2. Connect the EVAP purge tube to the intake manifold. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Connect the EVAP canister purge tube to the purge valve. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement 
  5. Install the intake manifold. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals