LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Disconnecting Evaporative Emission (EVAP) Canister Harness Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) canister harness electrical connector (2) from the EVAP vent solenoid valve.
  3. Clean away any debris that may be present around the EVAP canister vent solenoid valve.
    4. Fig 2: Disconnecting Fuel Tank Evaporative Emission Line Quick Connect Fittings
    GM1656958Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister bolt (5).
  5. Lower the EVAP canister (4).
    6. Fig 3: Rotating EVAP Canister Vent Valve Counterclockwise
    GM889735Courtesy of GENERAL MOTORS CORP.
  6. Rotate the EVAP canister vent solenoid valve counterclockwise in order to release it from the locked position.
    7. Fig 4: View Of EVAP Canister Vent Valve
    GM889736Courtesy of GENERAL MOTORS CORP.
  7. Remove the EVAP canister vent solenoid valve from the canister.
scientia non olet · About LEMON Manuals