LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Vent Valve
    GM889736Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid valve into the EVAP canister, with the valve aligned to the released position.
    2. Fig 2: Rotating EVAP Canister Vent Valve Clockwise
    GM889735Courtesy of GENERAL MOTORS CORP.
  2. Rotate EVAP canister vent solenoid valve clockwise in order to secure it into the locked position.
    3. Fig 3: Installing EVAP Canister And Bolt
    GM1656958Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister (4) and bolt (5).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 4: Connecting EVAP Canister Harness Electrical Connector To Vent Solenoid Valve
    GM1652166Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister harness electrical connector (2) to the vent solenoid valve.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals