LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Disconnecting Evaporative Emission (EVAP) Canister Harness Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) canister harness electrical connector (1) from the EVAP canister pressure sensor.
  3. Disconnect the EVAP canister harness electrical connector (2) from the EVAP canister vent solenoid valve.
  4. Disconnect the fuel fill vent pipe quick connect fitting (2) from the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 2: Disconnecting Fuel Tank EVAP Line Quick Connect Fittings
    GM1651435Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fuel tank EVAP line quick connect fittings (1, 3) from the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    6. Fig 3: Removing EVAP Canister Bolt
    GM1652165Courtesy of GENERAL MOTORS CORP.
  6. Remove the EVAP canister bolt.
  7. Slide the EVAP canister assembly toward the driver side of the vehicle in order to remove.
    8. NOTE: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.
  8. If reusing the EVAP canister, inspect the canister for loose carbon particles.
scientia non olet · About LEMON Manuals