LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Insert the retaining tab on the EVAP canister into the slotted bracket on the vehicle underbody.
    2. Fig 1: Installing EVAP Canister Bolt
    GM1652165Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the EVAP canister bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Connecting Fuel Tank EVAP Line Quick Connect Fittings
    GM1651435Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel tank EVAP line quick connect fittings (1, 3) to the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Connect the fuel fill vent pipe quick connect fitting (2) to the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 3: Connecting EVAP Canister Harness Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP canister harness electrical connector (1) to the EVAP canister pressure sensor.
  6. Connect the EVAP canister harness electrical connector (2) to the EVAP canister vent solenoid valve.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals