LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Purge Valve
    GM1578478Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve to the bracket.
  2. Position the EVAP canister purge valve with bracket to the cylinder head.
    3. NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister purge valve bracket bolt.

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

    4. Fig 2: Identifying EVAP Vapor Line
    GM1652164Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 3: Identifying Chassis EVAP Vapor Line
    GM1623766Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    6. Fig 4: Locating EVAP Purge Solenoid Electrical Connector
    GM1647981Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine harness electrical connector (2) to the EVAP canister purge valve.
  7. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals