LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the starter. Refer to Starter Motor Replacement (RPOs L61/LE5) or Starter Motor Replacement (RPO LSJ) .
    2. Fig 1: Disconnecting Crankshaft Position (CKP) Sensor Wiring Harness Electrical Connector From CKP Sensor
    GM1656996Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the crankshaft position (CKP) sensor wiring harness electrical connector from the CKP sensor.
  3. Remove the CKP sensor bolt.
    4. Fig 2: Removing CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  4. Remove the CKP sensor.
scientia non olet · About LEMON Manuals