LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement-Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
    2. Fig 1: Identifying Exhaust Camshaft Position (CMP) Sensor Electrical Connector
    GM1647999Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the exhaust camshaft position (CMP) sensor electrical connector (1).
  3. Remove the CMP sensor bolt. Intake CMP shown, exhaust CMP similar.
    4. Fig 2: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals