LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement-Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Inspect the CMP sensor for damage, replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
    2. Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the CMP sensor. Intake CMP shown, exhaust CMP similar.
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CMP Sensor Electrical Connector
    GM1647999Courtesy of GENERAL MOTORS CORP.
  4. Connect the exhaust CMP sensor electrical connector (1).
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals