LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the solenoid valve O-ring seals with clean engine oil.
    NOTE: Refer to Fastener Notice .
    2. Fig 1: Identifying CMP Actuator Solenoid Valve
    GM1578482Courtesy of GENERAL MOTORS CORP.
  2. Install the intake (2) CMP actuator solenoid valve and bolt, as required.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Install the exhaust (1) CMP actuator solenoid valve and bolt, as required.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Install the camshaft cover. Refer to Camshaft Cover Replacement .
scientia non olet · About LEMON Manuals