LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor Engine Harness Electrical Connector
    GM1647998Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  3. Release the air cleaner latches.
    4. Fig 2: Identifying Air Cleaner Assembly
    GM1652246Courtesy of GENERAL MOTORS CORP.
  4. Separate the upper and lower portions of the air cleaner assembly.
  5. Remove the air cleaner filter from the lower air cleaner housing.
  6. Inspect the air cleaner filter for dust, dirt, and water contamination.
scientia non olet · About LEMON Manuals