LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor Engine Harness Electrical Connector
    GM1647998Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
    3. Fig 2: Removing Air Cleaner Nuts
    GM1657015Courtesy of GENERAL MOTORS CORP.
  3. Remove the air cleaner nuts.
  4. Remove the air cleaner assembly. Pull up the front leg of the housing in order to disengage the housing from the stud.
scientia non olet · About LEMON Manuals