LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Air Cleaner
    GM1657015Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner, push down the front leg of the housing in order to seat the housing onto the stud.
  2. NOTE: Refer to Fastener Notice .
  3. Install the air cleaner nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  4. Fig 2: Installing Air Cleaner Outlet Duct
    GM1647998Courtesy of GENERAL MOTORS CORP.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  6. Connect the engine harness electrical connector to the MAF/IAT sensor.