LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls - 2.0L - DTC P0351 To DTC P2138) >> Diagnostic Information & Procedures >> DTC P0685, P0689, or P0690 >> Repair Procedures

Repair Procedures

WARNING: This page is about a different variant/trim than selected.
  1. Refer to Engine Control Module (ECM) Replacement for ECM replacement, setup, and programming.
  2. Clear the DTCs with a scan tool.
  3. Turn OFF the ignition for 30 seconds.
  4. Start the engine. If engine does not run, refer to Engine Cranks but Does Not Run .
  5. If other DTCs are set, refer to Diagnostic System Check - Vehicle .