Circuit/System Testing for DTC
WARNING: This page is about a different variant/trim than selected.
P0601, P0602, P0603, P0604, P0606, P0607, P062F and P2610
- Observe the DTCs with the scan tool.
- If DTC P0602 is set, attempt to program the ECM before replacing the ECM. Refer to Service Programming System (SPS) .
- If DTC P0602 resets, replace the ECM.
- Test the voltage and ground circuits to the control module for the following:
- A short
- An open
- High resistance
- If all circuits test OK, replace the ECM.