LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls - 2.0L - DTC P0351 To DTC P2138) >> Diagnostic Information & Procedures >> DTC P0443 or P0449 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

P0443 

With the ignition ON, engine OFF, you should hear a clicking sound when the EVAP canister purge solenoid valve is commanded to 50 percent with a scan tool. The clicking sound should stop when the EVAP canister purge solenoid valve is commanded to 0 percent. The rate at which the valve cycles should increase when the commanded state is increased, and decrease when the commanded state is decreased.

P0449 

  1. With the ignition ON and the engine OFF, command the EVAP vent solenoid ON and OFF with a scan tool.
  2. Listen for a click when the valve operates. Verify that both the ON, and the OFF states are commanded.
scientia non olet · About LEMON Manuals