Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

To help locate intermittent leaks, use the J41413-200 Evaporative Emission System Tester (EEST) to introduce smoke into the EVAP system. Move all EVAP components while observing smoke with theJ41413-SPT High Intensity White Light.
To improve the visibility of the smoke exiting the EVAP system, observe the suspected leak area from different angles with the J41413-SPT .
A condition may exist where a leak in the EVAP system only exists under a vacuum condition. By using the scan tool Purge/Seal function to create a vacuum, seal the system and observe the FTP parameter for vacuum decay, this type of leak may be detected.