LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls - 2.4L - DTC P0010 To DTC P0341) >> Diagnostic Information & Procedures >> DTC P0010, P0011, P0013, or P0014 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ensure the vehicle has the proper oil viscosity.
  2. Observe the engine oil level. The engine oil level should be within the operating range.
  3. Allow the engine to reach operating temperature.
  4. Increase the engine speed to 1,500 RPM.
  5. Command each CMP actuator to 25 percent. The CMP actuator angle desired parameter should match the CMP actuator actual parameter.
scientia non olet · About LEMON Manuals