LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Quick Connect Fitting(s) Service (Plastic Collar) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Lubricating Male Pipe End
    GM155425Courtesy of GENERAL MOTORS CORP.
  1. Apply a few drops of clean engine oil to the male connection end.
    2. Fig 2: Connecting Fittings (Plastic Collar)
    GM155771Courtesy of GENERAL MOTORS CORP.
  2. Push both sides of the quick connect fitting together in order to cause the retaining feature to snap into place.
    3. Fig 3: Ensuring Secure Connection
    GM155399Courtesy of GENERAL MOTORS CORP.
  3. Once installed, pull on both sides of the quick connect fitting in order to make sure the connection is secure.
scientia non olet · About LEMON Manuals