LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (SCIP) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating SCIP Sensor & BARO Sensor
GM1389393Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: Use the new SCIP sensor seal provided with the new SCIP sensor.
  1. Install the SCIP sensor (1) into the intake manifold.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  2. Connect the SCIP sensor harness connector.
scientia non olet · About LEMON Manuals