LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the starter. Refer to Starter Motor Replacement (RPOs L61/LE5) or Starter Motor Replacement (RPO LSJ) in Engine Electrical.
    2. Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the knock sensor (KS) harness connector.
  3. Remove the KS retaining bolt.
  4. Remove the KS.
scientia non olet · About LEMON Manuals